Buell 2007 FIREBOLT Service Manual page 627

HOME
12. See Figure 7-90. Position the cam position sensor wire
bundle, the voltage regulator wire bundle and the oil
pressure switch wiring inboard, then push the wire bun-
dle up against the return oil line and cable strap them to
the return oil line.
13. See Figure 7-92. Capture the main wire harness bundle,
the vehicle speed sensor lead, the stator bundle, and the
muffler actuator cable (if applicable) to the oil return line
with a cable strap.
14. See Figure 7-91. Connect the vehicle speed sensor last.
12370
12012a
1. Stator connector [46]
2. Oil pressure switch wiring
3. Vehicle speed sensor connector [65]
4. Gear cover vent line with cover (to protect wiring)
5. Extended wire guard to protect wiring
6. Main harness
7. Interactive exhaust cable
8. Cable wrap securing Interactive exhaust cable and
main harness to oil return line
7-72 2007 Buell Firebolt: Electrical
7
8
9
10
12
14
Figure 7-89. Sprocket Cover Wiring and Connections
NOTE
The vehicle speed sensor is positioned below the vent
line filling in order for the front sprocket cover to conform
to the additional components.
See Figure 7-92. Make sure main harness (2) is routed
around sprocket cover boss (1).
15. Install sprocket cover. See
6
4
5
3
11
13
1
12369a
9. Location of neutral switch
10. Voltage regulator connector [77], behind cam posi-
tion sensor (is also part of the bundle secured to
the cam position sensor with a cable strap)
11. Cam position sensor connector [14]
12. Neutral safety switch (single bullet) [131]
13. Cable strap securing neutral connector to cam
position sensor connector [14]
14. Position of forward cable straps to secure wiring
2.30 SPROCKET COVER.
2
5