Buell 2007 FIREBOLT Service Manual page 248

HOME
10646a
1. Fuel line connection
2. Connection for throttle position sensor [88]
3. Connections for fuel injectors [84 & 85]
NOTE
Remove shop towel from entrance of throttle body to ensure
proper operation of induction module.
13. See Figure 3-12. Connect throttle position sensor [88].
14. Connect fuel injector leads [84 & 85].
15. Connect fuel line (1).
16. Install throttle body velocity stack with retaining ring.
17. Install air filter base plate. See
ASSEMBLY.
18. Install muffler. See 2.28 EXHAUST
NOTE
For 1200 model motorcycles with interactive exhaust systems
see 7.6 INTERACTIVE EXHAUST SYSTEM (XB12
19. Install intake cover. See
BLY.
20. Install rear belt and idler pulley. See
SYSTEM.
21. Install left side rider footpeg mount. See
HEEL GUARD AND MOUNT.
22. Install sprocket cover. See
23. Install chin fairing. See 2.33 CHIN FAIRING.
24. Install air scoops, right and left sides. See
SCOOPS.
25. Connect fuel pump. See
Figure 3-12. Fuel Line and DDFI Electrical Connections (Typical)
4.44 AIR CLEANER
SYSTEM.
MODEL).
2.34 INTAKE COVER ASSEM-
6.6 DRIVE BELT
2.29 FOOTPEG,
2.30 SPROCKET COVER.
2.35 AIR
4.39 FUEL PUMP.
2
NOTE
The connection for fuel pump is just above the pump located
at the rear of the fuel tank on the left side of the vehicle.
11 1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
26. Connect negative ground cable to battery and tighten
fastener to 72-96 in-lbs (8-11 Nm).
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
27. Install seat. See 2.38 SEAT.
2007 Buell Firebolt: Engine
3
1
WARNING
WARNING
3-17