Buell 2007 FIREBOLT Service Manual page 602

HOME
INSTALLATION
Front
1. See Figure 7-52. Insert bullet connectors and wiring
through hole in fairing (5) and fairing support bracket (4).
2. Install turn signal (1) using lockwasher (2) and fastener
(3). Tighten fastener to 25-28 in-lbs (2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-51.
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition/key switch to ON.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition/key switch to OFF.
Rear
1. Insert bullet connectors through license plate bracket (4)
and tail section.
2. Install reflector bracket.
a. Place license plate bracket into position over
threads on turn signal.
b. Be sure tab on turn signal fits into hole in reflector
bracket and tab on reflector bracket fits into hole in
license plate bracket.
3. Attach turn signal using lockwasher and fastener.
Tighten fastener to 25-28 in-lbs (2.8-3.2 Nm).
4. Attach bullet connectors on turn signal wires as shown in
Figure 7-54.
Left turn signal
Tail lamp
Tail lamp ground
[18A]
[18A]
Right turn signal
Figure 7-54. Rear Turn Signal Connections
1 1
WARNING WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition/key switch to ON.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition/key switch to OFF.
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
6. Install tail frame upper bodywork. See
TAIL ASSEMBLY AND BODY
7. Install seat. See 2.38 SEAT.
2007 Buell Firebolt: Electrical
b1099x7x
[19A] [19B]
V
1
1
[19B]
[19A]
BK
2 2
[93A] [93B]
O/W
1 1
2 2 R/Y
[93B]
[93A]
BK
1 1
[18A]
BN
1 1
[18A]
BK
2
2
2.36 SUBFRAME
WORK.
7-47