Buell 2007 FIREBOLT Service Manual page 300

HOME
a0101x3x
Position ring end gaps at arrows–
minimum of 90° apart
FRONT
Piston
pin
REAR
Figure 3-103. Ring End Gap Position
5. See Figure 3-103. Make sure the piston ring end gaps
are properly positioned as shown.
8672
Figure 3-104. Piston Support Plate
6. See Figure 3-104. Turn engine until piston is resting on
top of PISTON SUPPORT PLATE (Part No. HD-42322).
7. Lubricate cylinder wall, piston, pin and rod bushing with
engine oil.
8. Remove protective sleeves from cylinder studs. Install a
new cylinder base gasket. Make sure the piston does not
bump the studs or crankcase.
8671
1. Piston ring compressor (Part No. HD-96333-51C)
Figure 3-105. Compressing Piston Rings
9. See Figure 3-105. Compress the piston rings using PIS-
TON RING COMPRESSOR (Part No. HD-96333-51E).
10. Install cylinder over piston.
11. Remove PISTON RING COMPRESSOR.
NOTE
Push rod covers must be installed prior to installing cylinder
heads.
12. Assemble and install cylinder head. See
HEAD.
13. Rotate engine back up into frame.See
ROTATION FOR SERVICE.
3.6 CYLINDER
3.3 ENGINE
2007 Buell Firebolt: Engine 3-69