Buell 2007 FIREBOLT Service Manual page 146

Table of Contents

Advertisement

HOME
b0935x2x
6
1.
Front axle
2.
Wheel bearing
3.
Front wheel
4.
Front brake springs (6)
5.
Front wheel spacer
Front Rotor Installation
1.
See
Figure 2-17.
Install new spring (4).
2.
Install new washers (9).
3.
Install new drive bushings (8) into rotor.
NOTE
Note the identifying mark of rotor is up and radius end of drive
bushing (8) toward center of wheel.
4.
Align reference dot on front rotor with the valve stem.
CAUTION
Do not re-use brake disc screws. Re-using disc screws
can result in torque loss and damage to rotor and/or
brake assembly. (00319b)
3
4
5
2
8
7
Figure 2-17. Front Wheel Assembly
2
9
6.
Front brake rotor
7.
Rotor mount fastener (6)
8.
Drive bushings (6)
9.
Washers (6)
5.
Install new rotor mounting fasteners in a criss-cross pat-
tern around the wheel to insure proper fitting between
rotor, fastener and bushing. Tighten to 25-27 ft-lbs (34-
37 Nm).
11
1
WARNING
Rotor mounting fasteners must be seated into drive
bushings and drive bushings must be fitted into rotor
properly. Failure to comply can affect braking ability and
lead to brake failure which could result in death or seri-
ous injury. (00499b)
2007 Buell Firebolt: Chassis
1
WARNING
2-15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Firebolt series

Table of Contents