Engine Installation - Buell 2007 FIREBOLT Service Manual

HOME

ENGINE INSTALLATION

ASSEMBLY
Engine Prep for Re-installation
NOTE
Install components that were removed from engine as were
necessary for service prior to installing engine in frame.
8723a
Figure 3-33. Rear Isolator and Mounting Hardware
1. See Figure 3-33. Install rear isolator assembly by install-
ing the two rear fasteners first and then the two forward
fasteners (re-install with new fasteners). Tighten to 25-27
ft-lbs (33.9-36.6 Nm).
8725
Figure 3-34. Center Tie Bar Mount
2. Install the following items on the engine assembly as
required:
a. Shifter assembly. See
b. See Figure 3-34. Center tie bar mount 30-33 ft-lbs
(40.6-44.7 Nm).
NOTE
Hand thread pivot shaft into crankcase prior to installing the
threaded insert. Remove pivot shaft after installing the
threaded insert.
c. See Figure 3-35. Apply LOCTITE 242 (blue) to swin-
garm pivot shaft pinch bolt threaded insert and
install.
6.2 PRIMARY COVER.
d. See Figure 3-36. Aluminum bushings from front
exhaust mount.
e. Wire guard under the sprocket cover.
8770
8729
Figure 3-35. Threaded Insert
8718
Left Side
8727
Right Side
Figure 3-36. Front Exhaust Mount Bushings (2 piece)
2007 Buell Firebolt: Engine
3.5
3-29