Ignition Coil - Buell 2007 FIREBOLT Service Manual

HOME

IGNITION COIL

REMOVAL
1 1
WARNING WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1. Disconnect negative battery cable.
2. Remove intake cover assembly. See
COVER ASSEMBLY.
3. Remove air cleaner cover. See
ASSEMBLY.
4. See Figure 4-72. Disconnect the spark plug cables from
the coil plug posts (1, 5).
5. Detach connector (3) [83].
6. Remove coil fasteners (2).
INSTALLATION
NOTE
To ease installation, install spark plug cables to ignition coil
first.
1. Connect spark plug cables to ignition coil.
2. See Figure 4-72. Attach coil to frame with fasteners (2).
Tighten to 120-144 in-lbs (13.6-16.3 Nm).
3. Attach front and rear spark plug cables to ignition coil
posts.
4. Attach connector (3) [83].
5. Install air cleaner cover. See
ASSEMBLY.
6. Install intake cover assembly. See
ASSEMBLY.
7. Connect negative battery cable.
2.34 INTAKE
4.44 AIR CLEANER
4.44 AIR CLEANER
2.34 INTAKE COVER
8843
1
2
1. Front cylinder post
2. Fasteners
3. Coil connector [83]
4. Coil
5. Rear cylinder post
Figure 4-72. Ignition Coil Location
b0993x4x
2
1
1. Rear cylinder post
2. Coil pin A (rear cylinder)
3. Coil pin B (12 VDC)
4. Coil pin C (front cylinder)
5. Front cylinder post
Figure 4-73. Ignition Coil
2007 Buell Firebolt: Fuel System
4.32
3
4
5
3 4
5
4-99