Buell 2007 FIREBOLT Service Manual page 541

HOME
12044
Figure 6-82. Install Nut (Part No. HD-47856-5) (Typical)
6. See Figure 6-82. Thread nut (Part No. HD-47856-5) onto
end of adapter, until it tightens against installer.
6-44 2007 Buell Firebolt: Drive/Transmission
12089
1
2
3
1. Crowfoot wrench
2. 1/2 inch breaker bar
3. Adjustable wrench
Figure 6-83. Press Seal Into Crankcase
7. See Figure 6-83. Place crowfoot wrench (Part No. HD-
47856-7) (1) with 1/2 inch drive breaker bar (2) on large
nut. Place an adjustable wrench (3) on flats of hex head
cast into end of adapter.
8. Holding smaller wrench, tighten nut with larger wrench
until outer face of seal is flush with outer edge of crank-
case bore.
NOTE
It is acceptable to recess seal to about 0.030 in. (0.762 mm)
below outer edge of bore. Seal will be controlled by tool.
9. Remove nut, installer, adapter and pilot.