Inner Thread Eyelet Base Removal - Brother PR600II Service Manual

Hide thumbs Also See for PR600II:
Table of Contents

Advertisement

Main unit
3

Inner thread eyelet base removal

1. Remove the 2 screws 1, and then remove the inner thread eyelet base
assembly from the tension base assembly.
2. Remove the tension axis cap 1. (6 locations)
3. Loosen the thread guide tension axis 2, and then remove the spring
and the thread guide tension plate 3. (6 locations)
4
Thread sensor PCB assembly and head PCB assembly removal
1. Disconnect the FFC (SML2CD-H) from the head PCB assembly 1.
(6 locations)
2. Remove the 4 screws 1, and then remove the head PCB assembly.
3. Remove the 2 screws 2, and then remove the thread tension bracket,
thread quantity sensor cover, and head grounding wire assembly.
(6 locations)
4. Remove the 2 retaining rings CS2, and then remove the 2 rubber washers
and the thread sensor assembly 2 from the thread quantity sensor cover.
(6 locations).
5. Remove the FFC (SML2CD-H) from the thread sensor assembly.
2 - 66
Thread tension unit
1
S52
S52
1
2
1
2
3
1
1
1
2
Retaining ring CS2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pr620

Table of Contents