Brother PR600II Service Manual page 104

Main unit
7
Board case attachment
1. Attach the board case 1 with the 2 screws 1.
*Key point
• Insert the hook on the board case into the positioning hole on
the PCB attachment plate, and then slide the hook into
position.
• Route the inverter lead wire 2 inside the board case 1.
2. Attach the clip 3 with the screw 2.
1
2
8
Operation panel B assembly
1. Attach the cord bushing 3 to USB lead wire assembly A 1 and the panel
lead wire assembly 2.
*Key point
• Open the lid of the cord bushing 3, attach the cord bushing to
the lead wires, and then close the lid.
• The distance from the cord bushing 3 to the tip of each lead
wire should be 80 ±5 mm.
2. Insert USB lead wire assembly A 1 and the panel lead wire assembly 2
from the back of operation panel B as shown in the photo on the right.
*Key point
• Make sure that the lock holding the cord bushing 3
completely passes through the hole until it reaches the inside
of operation panel B.
3 - 6
Operation panel
Screw, Bind
M3X4
Torque
0.49 – 0.69 N-m
3
1
1 2
3 1
2
2
1
3
2
3