Brother PR600II Service Manual page 247

Hide thumbs Also See for PR600II:
Table of Contents

Advertisement

Test mode
4. [MAIN MOTOR TEST]
[MOVE ORIGIN POSITION] : Adjusts the angle of the main shaft to the needle top stop position.
[ROTATE MAIN MOTOR]
[STOP MAIN MOTOR]
[<] [>]
[<<] [<] - [>] [>>]
[CLOSE]
5. [XY MOTOR TEST]
The X waveform table and Y waveform table numbers are displayed to the right of [SELECT x] and [SELECT Y], depending
on the settings for [SPEED] and [PITCH].
[MOVE ORIGIN POSITION] : After returns the X and Y carriages to their origins, moves the center of S hoop.
[↑][←][→][↓]
[SAVE]
[<][>] (SPEED)
[<][>] (PITCH)
[<][>] (REPEAT)
[SELECT X]
[SELECT Y]
[XY STOP]
[CLOSE]
: Rotates the main shaft at the preset speed.
: Stops the main shaft.
: Sets the motor speed.
: Changes the main shaft warm-up time. (Continuous [-] to 100 min)
: Closes the <MAIN MOTOR TEST> screen.
: Changes the X and Y carriage origins. (-10 ~ 10)
: Saves changes to the X and Y carriage origins in the EEPROM.
: Sets the motor speed. (100 ~ 1200)
: Sets the pitch. (0.0 ~ 20.0)
: Sets the number of repeats. (1 ~ 10)
: Moves the X carriage at the preset speed, pitch, and repeat. The carriage stops if
this button is pressed during movement.
: Moves the Y carriage at the preset speed, pitch, and repeat. The carriage stops if
this button is pressed during movement.
: Stops the X and Y carriage movement.
:Closes the <CY MOTOR TEST> screen.
4 - 7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pr620

Table of Contents