Brother PR600II Service Manual page 217

Test mode
11. Default setting
Select this mode to initialize the panel settings.
Items to be initialized are listed below.
[Editing information]
Parameters
Thread spool
Reserved thread
Sewing area display
Grid display
Cursor display
Sewing order display
Display expanded thread color OFF
Thread selection
DST thread trimming feed
Deleting short stitches
Remaining length of thread
Units of measurements
Custom thread table 1, 2
Starting / Ending position
Lock stitch
Maximum speed
[System setup data]
• Language (reset to the factory-set language.)
• Resumption (operation is not resumed even when suspension is released. Number of switches is returned to
[0].)
• Buzzer: [Beep] is set.
[Empty pocket]
Empties the pocket data.
12. Clear trip
When this mode button is selected, the current values for the stitch counter and sewing time counter (Total and Trip) are
displayed on the left side, and the [Clear trip] button is displayed on the right side of the screen.
Pressing the [Clear trip] button resets [Trip Stitches] and [Trip Time] to zero.
Default
All color information set for spools is cleared, resulting
in no spool set.
All spools are released.
LL frame area is displayed.
Only the center is displayed.
A small cross cursor is displayed.
Name of Color
Brother's original pallet
+3 when thread trimming is turned on
0.3 mm or less
Standard
mm
All registered custom settings are reset.
Center (both start and end of sewing)
ON
Tubular frame: 600 rpm
Cap frame: 400 rpm
4 - 15