Rack And Hook Holder Link Removal - Brother PR600II Service Manual

Hide thumbs Also See for PR600II:
Table of Contents

Advertisement

Main unit
3

Rack and hook holder link removal

1. Remove the 2 screws 1, and then remove the needle thread sensor
assembly.
2. Remove the 2 retaining rings E4, and then remove the rack assembly.
3. Remove the retaining ring E3, and then remove the hook holder link from
the rack assembly.
4
TH motor assembly and LED light assembly removal
1. Remove the screw 1, and then remove the LED light assembly 1.
*Key point
• Remove the lead wire of the LED light assembly 1 from the
lead wire guide 2.
2. Remove the 2 screws 2, and then remove the lead wire guide 2.
3. Remove the 2 screws 3, and then remove the TH motor assembly 3 and 2
spacers.
4. Remove the 2 screws 4, and then remove the base plate assembly 4 from
the thread guide base.
2 - 28
Needle thread unit
Retaining ring E4
Retaining ring E3
3
2
2
3
1
4
4
1
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pr620

Table of Contents