Main unit
12
Hoop sensor removal
1. Remove the screw 1.
2. Remove the screw 2, and then remove the hoop lever.
3. Remove the nut 1 and the plain washer S6, and then remove the hoop
sensor assembly and the spring
Start movie clip (CD-ROM version only)
13
X-guide shaft removal
1. Remove the 2 nuts (2, M6) 1 on both ends of the X-guide shaft, 2 plain
washers (6) 2, and 2 spring washers (2-6) 3. Then remove the X-guide
shaft and the 2 bearing case X assemblies from the feed frame assembly.
2. Remove the retaining ring E4, and then remove the X-roller from the
bearing case X assembly (2 sets).
3. Remove the 2 external retaining rings C21, and then remove the linear
bearing (12) from the bearing case X assembly (2 sets).
2 - 22
Feed unit
.
S44
1
1
S44
2
1
3
2
Retaining ring E4
External retaining rings C21
2
3
1