Brother PR600II Service Manual page 26

Main unit
6
Base cover L removal
1. Remove the 2 screw covers 1.
2. Remove the 2 screws 1, and then remove the base cover L lid 2.
3. Remove the 3 screws 2, and then remove the base cover L 3.
*Key point
• Fully draw the feed final assembly toward you before
removing the base cover L.
Start movie clip (CD-ROM version only)
7
LED drive PCB removal
1. Disconnect the lead wire connector 2 on the LED drive PCB assembly 1
from the Main PCB.
2. 2.Remove the 2 screws 1, and then remove the LED drive PCB assembly
1.
2 - 8
Main parts
1
2
1
3
2
1 1
2