Driving jump assembly (1)
1. Attach the J cushion pin 2 and the J cushion 3 to the J base assembly 1,
and then tighten the screw 1.
2. Apply MOLYKOTE EM-30L to the shaft hole 4 on the J base assembly.
3. Thread the spring
and insert the J driving lever assembly to the J base assembly.
• Hang the U-shaped hook 6 of the spring
driving lever assembly, and then the other hook 7 over the J
Start movie clip (CD-ROM version only)
Apply MOLYKOTE EM-30L to the shaft hole on the J
Upper shaft unit
through the shaft of the J driving level assembly 5,
Set Screw, Socket (FT)
over the J
Size of a grain of
0.59 – 0.78 N-m
J LEVER SPRING
3 - 45