Maintenance; Cleaning The Lens; Cleaning The Exterior Of The Projector - Barco HDF Use And Installation Manual

15. MAINTENANCE

About this chapter
This chapter contains detailed maintenance procedures like dust filter replacement, lens cleaning etc. These procedures can easily
be performed by the operator of the projector.

15.1 Cleaning the lens

To minimize the possibility of damage to optical coatings, or scratches to lens surfaces follow the cleaning
procedure as described here precisely.
Necessary tools
• Compressed air.
• Clean Toraysee® cloth or any micro fiber lens cleaning cloth.
• Clean cotton cloth.
Necessary parts
Lens cleaner (e.g. Carl Zeiss lens cleaner or Purasol® or any water-based lens cleaner)
How to clean the lens?
Blow off dust with clean compressed air (or pressurized air cans
Clean with lens cleaner together with a clean lens cleaning cloth to remove the dust and contamination. Use big wipes in one single
direction.
Warning: Do not wipe back and forwards across the lens surface as this tends to grind dirt into the coating.
Use a dry lens cleaning cloth to remove left liquid or stripes. Polish with small circles.
If there are still fingerprints on the surface, wipe them off with lens cleaner together with a clean lens cleaning cloth. Polish again
with a dry one.
If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty cloth.

15.2 Cleaning the exterior of the projector

How to clean the exterior of the projector ?
Switch off the projector and unplug the projector from the mains power net.
Clean the housing of the projector with a damp cloth. Stubborn stains may be removed with a cloth lightly dampened with a mild
detergent solution.
5. Pressurized air cans are not efficient if there is too much dust on the surface, the pressure is too low
R5905158 HDF SERIES 16/06/2015
5
) .
15. Maintenance
273