Suspension Of The Hdf Series Projector With Rigging Clamps - Barco HDF Use And Installation Manual

3. Physical installation
Volt meter
After starting up the projector (lamp ignition) check if the value indicated by the volt meter is still within the specified power range of
the projector. Note that in case the power net drops significantly during start up, the lamp will fail the ignite. If this is the case, take
the necessary measures to reinforce the power net to the projector before starting up the projector again.
Volt meter is protected with a Miniature Fuse, 5 x 20 mm, T 1AH, 250 VAC, UL: 115 V - 300 VDC.
Spare power plug
The projector is delivered with a spare power plug. This spare power plug is attached behind the nameplate of the projector. Remove
the cover of the lamp first to access this spare power plug. Note that only qualified technical personnel may install a new power plug.
N
2
PE
4
Image 3-37
Pin configuration power plug HAN Q4/2 + PE.
3.4

Suspension of the HDF series projector with rigging clamps

Rigging points and rigging clamps
The carrying handle, at the bottom side of the projector, is provided with eight slots. Four slots are longitudinally (A) oriented and
four slots are transversely (B) oriented. Each slot contains a rigging point of which the position in the slot can be adjusted depending
on the size of the truss installation. The rigging clamps (C) can be attached to those rigging points, which allows an easy and fast
physical setup of the projector in a hanging configuration.
Image 3-38
Rigging points
Necessary tools
• 24 mm open ended spanner.
• 17 mm open ended spanner.
Necessary parts
• Four rigging clamps (R820411).
• Safety chains.
How to install and to use the rigging clamps ?
Measure the distance, center tube as reference, between the two used support bars of the truss.
36
L
1
HAN Q4/2 +
3
A
B
C
R5905158 HDF SERIES 16/06/2015