Hardware Reset; Osd Opacity - Barco HDF Use And Installation Manual

1
Image 12-54
Rotate image
Select Warp adaptation, angle.
Use the ◄ or ► key to change the rotation Angle.
Or,
press ENTER to open the Warping Adaptations window. Use the ◄ or ► key to change the Angle.
Image 12-55
Warping adaptation, angle

12.7.14 Hardware Reset

What can be done ?
During some combinations of adjustments, it is possible that the warping get stuck. Than it is possible to reset the board and restart
from a clean adjustment.
How to reset
Use the arrow keys to select the Reset icon on the general icon bar at the bottom of the Warp adjust window.
Image 12-56
Hardware reset
The hardware will restart. It can take a while until the warp unit is available again.

12.7.15 OSD opacity

About the opacity of the OSD menus
During the warp adjustment process the OSD menu is displayed on top the warp grid. To see the grid and the grid points, reduce
the opacity of the OSD menu.
R5905158 HDF SERIES 16/06/2015
2
3
12. Alignment
171