Replacement Of The Dust Filter On The Front Side - Barco HDF Use And Installation Manual

17. Servicing
Take off the dummy cover plate.
Insert the new input module in its compartment.
Make sure the module seats in its sliders (2).
Pull in the module until the contacts (3) are fully inserted into the connectors.
Fixate both fixation screws.
1
Image 17-2
Fixate input
17.2 Replacement of the dust filter on the front side
Necessary parts
New HEPA dust filter for the front side (R9854470).
How to replace the HEPA dust filter on the front side
Remove the front cover of the projector, see "Removal of the front cover", page 275.
Remove the HEPA dust filter on the front side by pulling the two spring clamps away from the filter and then moving the filter forwards.
Image 17-3
Front filter
6
Insert a new HEPA filter by pulling the two spring clamps away and move the filter into position.
Caution: Make sure that the airflow indicated on the dust filter match with the airflow of the fans.
Reinstall the front cover of the projector, see "Installation of the front cover", page 278.
C
AUTION
6. High Efficiency Particulate Arrestant
284
1
:
Never install a used HEPA filter. Always install a new HEPA filter.
2
R5905158 HDF SERIES 16/06/2015