Barco HDF Use And Installation Manual page 312

E. Stacking HDF series projectors
Inclination
Image E-7
Inclination adjustment
If necessary, adjust the skew of the stacked projector with respect to the reference projector by turning the screw Q in or out using
a 8 mm Allen key. The screw Q is located behind the cover of the lamp, just above the volt meter. Adjust until the outline of the
hatch pattern is most symmetric with the reference hatch pattern.
Note: See procedure "Removal of the lamp cover", to access the skew adjustment screw Q.
Skew
Image E-8
Skew adjustment
Shift the hatch pattern horizontally and vertically until the outline of the hatch pattern is most symmetrically placed with respect to
the reference hatch pattern.
Note: Note that the "Shift" function is motorized, which means that you have to access the projector software, via the local
keypad or remote control unit, to operate the "Shift" function.
Shift
Image E-9
Shift adjustment
Zoom the hatch pattern in or out until the outline of the hatch pattern matches exactly the outline of the reference hatch pattern.
Note: Note that the "Zoom" function is motorized, which means that you have to access the projector software, via the local
keypad or remote control unit, to operate the "Zoom" function.
Zoom
Image E-10
Zoom adjustment
If necessary, repeat from step 2 until the hatch pattern of the stacked projector is perfectly aligned with the hatch pattern of the
reference projector.
308
Q
R5905158 HDF SERIES 16/06/2015
Q