A
Image 16-14
Lamp cover installaion
Secure the lamp cover by locking the two captive screws at the right side of the lamp cover.
Image 16-15
Captive screw locking
16.8 Installation of the input cover
W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the input cover
Install the input cover of the projector as follows:
Bring the input cover towards its final position (A),
then gently push the locking stud at the right top corner (B) into its receiver,
then gently push the locking stud at the right bottom corner (C) into its receiver.
R5905158 HDF SERIES 16/06/2015
:
This procedure may only be performed by qualified technical service personnel.
16. Removal and installation of the projector covers
B
C
281