Cable Input; Hdmi - Displayport Input (3D Input Module); Input Locking - Barco HDF Use And Installation Manual

8. Input
Dual HD :
• Swap links
8.3.5

5 cable input

How to select
Select 5 cable and press ENTER to open the selections
Image 8-11
Advanced settings, 5-cable
Use the ▲ or ▼ key to select the desired configuration and press ENTER to select.
When e.g. CVBS/S-VIDEO AUTO is selected, the projector discovers itself which type of signal is connected to it and loads the
correct settings.
For RGB selections, advanced settings are possible. To adjust these advanced settings, use the ▲ or ▼ key to select Advanced
settings and press ENTER. The advanced settings menu opens:
Press ENTER to toggle between [Analog] and [TTL].
8.3.6

HDMI - DisplayPort input (3D input module)

How to select
Select HDMI/DP and press ENTER to open the selections
Image 8-13
HDMI-Display port selection
Use the ▲ or ▼ key to select the desired input and press ENTER to select.
8.4

Input locking

What is possible?
The output signal can be locked on an internal sync signal or on the sync signal of one of the input sources. Or it can follow the
input of the Main window or Pip window. When locked to the corresponding input sync, the output will be shown without movement
artifacts. With locking to a specific input, a set of projectors can be kept in sync, no matter what input image is shown.
Input locking is grayed out when 3D is active. Input locking is set automatically to the 3D source.
76
Image 8-12
5 cable configuration
R5905158 HDF SERIES 16/06/2015