Static Routing; Ipv4 Static Route - ZyXEL Communications GS2210 Series User Manual

38.2 Static Routing

Click IP Application > Static Routing in the navigation panel to display the screen as shown.
Figure 228 IP Application > Static Routing
To enable IPv4 static route, configure the static route settings in the IP Application > Static
Routing > IPv4 Static Route screen.

38.3 IPv4 Static Route

Click IP Application > Static Routing > IPv4 Static Route in the navigation panel to display the
screen as shown.
Figure 229 IP Application > Static Routing > IPv4 Static Route
The following table describes the related labels you use to create a static route.
Table 160 IP Application > Static Routing > IPv4 Static Route
LABEL
Active
Name
Destination IP
Address
IP Subnet
Mask
Chapter 38 Static Route
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
This parameter specifies the IP network address of the final destination.
Enter the subnet mask for this destination. Routing is always based on network number. If
you need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host ID.
GS2210 Series User's Guide
331