Anti-Arpscan Status; Anti-Arpscan Host Status - ZyXEL Communications GS2210 Series User Manual

• Go to Basic Setting > Port Setup. Clear Active and click Apply. Then select Active and
click Apply again.
• Go to Application > Errdiable > Errdisable Recovery and set the interval for Anti-
arpscan. After the interval expires, the closed port(s) will become active and start receiving
packets again.
• Use the command port no inactive.
• Refer to the port logs to see when a port was closed.

34.2 Anti-Arpscan Status

Use this screen to see what ports are trusted and are forwarding traffic or are disabled. To open this
screen, click Advanced Application > Anti-Arpscan.
Figure 214 Advanced Application > Anti-Arpscan Status
The following table describes the labels in this screen.
Table 148 Advanced Application > Anti-Arpscan Status
LABEL
Anti-Arpscan is....
Port
Trusted
State

34.3 Anti-Arpscan Host Status

Use this screen to view blocked hosts and unblock ones connected to certain ports. To open this
screen, click Advanced Application > Anti-Arpscan > Host Status.
Chapter 34 Anti-Arpscan
DESCRIPTION
This shows whether Anti-arpscan is enabled or disabled on the Switch.
This field displays the port number of the Switch.
This field displays whether the port is trusted or untrusted. Anti-arpscan is not
performed on a trusted port.
This field displays whether the port can forward traffic normally (Forwarding) or is
disabled (Err-Disable).
GS2210 Series User's Guide
310