Service Access Control - ZyXEL Communications GS2210 Series User Manual

Table 185 Management > Access Control > Logins (continued)
LABEL
Retype to
confirm
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give users
higher privileges via the CLI. For more information on assigning privileges see the Ethernet Switch CLI
Reference Guide.
User Name
Password
Retype to
confirm
Privilege
Apply
Cancel

43.5 Service Access Control

Service Access Control allows you to decide what services you may use to access the Switch. You
may also change the default service port and configure "trusted computer(s)" for each service in
the Remote Management screen (discussed later). Click Access Control to go back to the main
Access Control screen.
Chapter 43 Access Control
DESCRIPTION
Retype your new system password for confirmation
Set a user name (up to 32 ASCII characters long).
Enter your new system password.
Retype your new system password for confirmation
Type the privilege level for this user. At the time of writing, users may have a privilege
level of 0, 3, 13, or 14 representing different configuration rights as shown below.
• 0 - Display basic system information.
• 3 - Display configuration or status.
• 13 - Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins,
administrator and enable passwords, and configuration information display.
• 14 - Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session's privilege level is greater than or equal to the
command's privilege level. The session privilege initially comes from the privilege of the
login account. For example, if the user has a privilege of 5, he/she can run commands
that requires privilege level of 5 or less but not more.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide
369