Configure Multiple Spanning Tree Protocol - ZyXEL Communications GS2210 Series User Manual

Table 52 Advanced Application > Spanning Tree Protocol > Status: MRSTP (continued)
LABEL
Forwarding Delay
(second)
Cost to Bridge
Port ID
Topology Changed
Times
Time Since Last
Change
Port
Port State
Port Role
Designated Bridge
ID
Designated Port
ID
Designated Cost
Root Guard State

13.8 Configure Multiple Spanning Tree Protocol

To configure MSTP, click MSTP in the Advanced Application > Spanning Tree Protocol screen.
See Multiple STP on page 123
Chapter 13 Spanning Tree Protocol
DESCRIPTION
This is the time (in seconds) the root switch will wait before changing states (that is,
listening to learning to forwarding).
Note: The listening state does not exist in RSTP.
This is the path cost from the root port on this Switch to the root switch.
This is the priority and number of the port on the Switch through which this Switch must
communicate with the root of the Spanning Tree.
This is the number of times the spanning tree has been reconfigured.
This is the time since the spanning tree was last reconfigured.
This field displays the number of the port on the Switch.
This field displays the port state in STP.
• Discarding - The port does not forward/process received frames or learn MAC
addresses, but still listens for BPDUs.
• Learning - The port learns MAC addresses and processes BPDUs, but does not
forward frames yet.
• Forwarding - The port is operating normally. It learns MAC addresses, processes
BPDUs and forwards received frames.
This field displays the role of the port in STP.
• Root - A forwarding port on a non-root bridge, which has the lowest path cost and is
the best port from the non-root bridge to the root bridge. A root bridge does not have
a root port.
• Designated - A forwarding port on the designated bridge for each connected LAN
segment. A designated bridge has the lowest path cost to the root bridge among the
bridges connected to the LAN segment. All the ports on a root bridge (root switch) are
designated ports.
• Alternate - A blocked port, which has a best alternate path to the root bridge. This
path is different from using the root port. The port moves to the forwarding state
when the designated port for the LAN segment fails.
• Backup - A blocked port, which has a backup/redundant path to a LAN segment
where a designated port is already connected when a switch has two links to the
same LAN segment.
• Disabled - Not strictly part of STP. The port can be disabled manually.
This field displays the identifier of the designated bridge to which this port belongs when
the port is a designated port. Otherwise, it displays the identifier of the designated bridge
for the LAN segment to which this port is connected.
This field displays the priority and number of the bridge port (on the designated bridge),
through which the designated bridge transmits the stored configuration messages.
This field displays the path cost to the LAN segment to which the port is connected when
the port is a designated port. Otherwise, it displays the path cost to the root bridge from
the designated port for the LAN segament to which this port is connected,
This field displays the state of the port on which root guard is enabled.
• Root-inconsistent - the Switch receives superior BPDUs on the port and blocks the
port.
• Forwarding - the Switch unbolcks and allows the port to forward frames again.
for more information on MSTP.
GS2210 Series User's Guide
132