ZyXEL Communications GS2210 Series User Manual page 181

Table 76 Advanced Application > Policy Rule (continued)
LABEL DESCRIPTION
Bandwidth Specify the bandwidth in kilobit per second (Kbps). Enter a number between 64 and
1000000.
Action
Specify the action(s) the Switch takes on the associated classified traffic flow.
Note: You can specify only one action (pair) in a policy rule. To have the Switch take multiple actions on the
same traffic flow, you need to define multiple classifiers with the same criteria and apply different policy
rules.
Say you have several classifiers that identify the same traffic flow and you specify a different policy rule for
each. If their policy actions conflict (Discard the packet, Send the packet to the egress port and Rate
Limit), the Switch only applies the policy rules with the Discard the packet and Send the packet to the
egress port actions depending on the classifier names. The longer the classifier name, the higher the
classifier priority. If two classifier names are the same length, the bigger the character, the higher the
classifier priority. The lowercase letters (such as a and b) have higher priority than the capitals (such as A and
B) in the classifier name. For example, the classifier with the name of class 2, class a or class B takes priority
over the classifier with the name of class 1 or class A.
Let's say you set two classifiers (Class 1 and Class 2) and both identify all traffic from MAC address
11:22:33:44:55:66 on port 3.
If Policy 1 applies to Class 1 and the action is to drop the packets, Policy 2 applies to Class 2 and the action is
to forward the packets to the egress port, the Switch will forward the packets.
If Policy 1 applies to Class 1 and the action is to drop the packets, Policy 2 applies to Class 2 and the action is
to enable bandwidth limitation, the Switch will discard the packets immediately.
If Policy 1 applies to Class 1 and the action is to forward the packets to the egress port, Policy 2 applies to
Class 2 and the action is to enable bandwidth limitation, the Switch will forward the packets.
Forwarding Select No change to forward the packets.
Select Discard the packet to drop the packets.
Priority Select No change to keep the priority setting of the frames.
Select Set the packet's 802.1 priority to replace the packet's 802.1 priority field with the
value you set in the Priority field.
Outgoing Select Send the packet to the mirror port to send the packet to the mirror port.
Select Send the packet to the egress port to send the packet to the egress port.
Select Set the packet's VLAN ID to replace the VLAN ID of the packets with the value you
configure in the VLAN ID field.
Rate Limit Select Enable to activate bandwidth limitation on the traffic flow(s).
Add Click Add to inset the entry to the summary table below and save your changes to the
Switch's run-time memory. The Switch loses these changes if it is turned off or loses power,
so use the Save link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to reset the fields back to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the policy index number. Click an index number to edit the policy.
Active This field displays Yes when policy is activated and No when is it deactivated.
Name This field displays the name you have assigned to this policy.
Classifier(s) This field displays the name(s) of the classifier to which this policy applies.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Chapter 22 Policy Rule
GS2210 Series User's Guide
181