ZyXEL Communications GS2210 Series User Manual page 226

Figure 157 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > Static Binding
The following table describes the labels in this screen.
Table 99 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > Static Binding
LABEL DESCRIPTION
ARP Freeze ARP Freeze allows you to automatically create static bindings from the current ARP
entries (either dynamically learned or static ARP entries) until the Switch's binding table
is full.
Note: The ARP learning mode should be set to ARP-Request in the IP Application >
Condition All - Select this and click ARP Freeze to have the Switch automatically add all the
current ARP entries to the static bindings table.
Port List - Select this and enter the number of the port(s) (separated by a comma).
ARP entries learned on the specified port(s) are added to the static bindings table after
you click ARP Freeze.
VLAN List - Select this and enter the ID number of the VLAN(s) (separated by a
comma). ARP entries for the specified VLAN(s) are added to the static bindings table
after you click ARP Freeze.
Static Binding
MAC Address Enter the source MAC address in the binding.
IP Address Enter the IP address assigned to the MAC address in the binding.
VLAN Enter the source VLAN ID in the binding.
Port Specify the port(s) in the binding. If this binding has one port, select the first radio
button and enter the port number in the field to the right. If this binding applies to all
ports, select Any.
Add Click this to create the specified static binding or to update an existing one.
Cancel Click this to reset the values above based on the last selected static binding or, if not
applicable, to clear the fields above.
Chapter 26 IP Source Guard
ARP Setup > ARP Learning screen before you use the ARP Freeze feature.
GS2210 Series User's Guide
226