Multiple Rapid Spanning Tree Protocol Status - ZyXEL Communications GS2210 Series User Manual

Table 51 Advanced Application > Spanning Tree Protocol > MRSTP (continued)
LABEL
Apply
Cancel

13.7 Multiple Rapid Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See
Note: This screen is only available after you activate MRSTP on the Switch.
Figure 98 Advanced Application > Spanning Tree Protocol > Status: MRSTP
The following table describes the labels in this screen.
Table 52 Advanced Application > Spanning Tree Protocol > Status: MRSTP
LABEL
Configuration
Tree
Bridge
Bridge ID
Hello Time
(second)
Max Age (second)
Chapter 13 Spanning Tree Protocol
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 13.1 on page 121
DESCRIPTION
Click Configuration to specify which STP mode you want to activate. Click MRSTP to
edit MRSTP settings on the Switch.
Select which STP tree configuration you want to view.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this switch.
This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC address.
This ID is the same for Root and Our Bridge if the Switch is the root switch.
This is the time interval (in seconds) at which the root switch transmits a configuration
message. The root bridge determines Hello Time, Max Age and Forwarding Delay.
This is the maximum time (in seconds) the Switch can wait without receiving a
configuration message before attempting to reconfigure.
GS2210 Series User's Guide
131
for more information on MRSTP.