Ipv6 Source Guard Port Setup - ZyXEL Communications GS2210 Series User Manual

Table 113 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (continued)
LABEL
Link Local
Add
Cancel
Clear
Index
Name
Validate Address
Validate Prefix
Link Local
Delete
Cancel

26.15 IPv6 Source Guard Port Setup

Use this screen to apply configured IPv6 source guard policies to ports you specify. Use port * to
apply a policy to all ports. To open this screen, click Advanced Application > IP Source Guard >
IPv6 Source Guard Port Setup.
Chapter 26 IP Source Guard
DESCRIPTION
Select Permit to allow data traffic from all link-local addresses; otherwise leave the
setting at Deny. A link-local address is an IPv6 unicast address that can be automatically
configured on any interface using the link-local prefix FE80::/10 and the interface
identifier in the modified EUI-64 format.
Click this to create the IPv6 source guard policy or to update an existing one.
Click this to reset the values above or if not applicable, to clear the fields above.
Click this to clear the fields above.
This field displays a sequential number for each policy.
This field displays the descriptive name for identification purposes for this IPv6 source
guard policy.
This field displays the Validate Address status for this IPv6 source guard policy.
This field displays the Validate Prefix status for this IPv6 source guard policy.
This field displays the Link Local traffic status for this IPv6 source guard policy.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Select an entry checkbox and click Delete to remove the specified entry.
Click this to clear the check boxes above.
GS2210 Series User's Guide
248