Configuring Dhcpv4 Vlan Settings - ZyXEL Communications GS2210 Series User Manual

Figure 240 DHCP Relay Configuration Example

40.4.6 Configuring DHCPv4 VLAN Settings

Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients.
Click IP Application > DHCP > DHCPv4 in the navigation panel, then click the VLAN link In the
DHCP Status screen that displays.
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch. See
information on how to do this.
Figure 241 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
Table 172 IP Application > DHCP > DHCPv4 > VLAN
LABEL
VID
Remote DHCP
Server 1 .. 3
Option 82
Profile
Chapter 40 DHCP
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Enter the IP address of a DHCP server in dotted decimal notation.
Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in this VLAN.
The Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the
profile to DHCP requests that it relays to a DHCP server.
GS2210 Series User's Guide
EXAMPLE
Section 5.2 on page 44
344
for