Configuring Snmp Trap Group - ZyXEL Communications GS2210 Series User Manual

Table 181 Management > Access Control > SNMP (continued)
LABEL
Set Community
Trap Community
Trap Destination
Version
IP
Port
Username
Apply
Cancel

43.3.1 Configuring SNMP Trap Group

From the SNMP screen, click Trap Group to view the screen as shown. Use the Trap Group
screen to specify the types of SNMP traps that should be sent to each SNMP manager.
Figure 257 Management > Access Control > SNMP > Trap Group
Chapter 43 Access Control
DESCRIPTION
Enter the Set Community, which is the password for incoming Set- requests from the
management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Use this section to configure where to send SNMP traps from the Switch.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
This username must match an existing account on the Switch (configured in
Management > Access Control > Logins screen).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide
364