Dhcpv4 Vlan Port Configure - ZyXEL Communications GS2210 Series User Manual

Table 172 IP Application > DHCP > DHCPv4 > VLAN (continued)
LABEL
Add
Cancel
Clear
VID
Type
DHCP Status
Delete
Cancel

40.4.7 DHCPv4 VLAN Port Configure

Use this screen to apply a different DHCP option 82 profile to certain ports in a VLAN. To open this
screen, click IP Application > DHCP > DHCPv4 > VLAN > Port.
Figure 242 IP Application > DHCP > DHCPv4 > VLAN > Port
The following table describes the labels in this screen.
Table 173 IP Application > DHCP > DHCPv4 > VLAN > Port
LABEL
VID
Port
Chapter 40 DHCP
DESCRIPTION
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This field displays the ID number of the VLAN group to which this DHCP settings apply.
This field displays Relay for the DHCP mode.
For DHCP server configuration, this field displays the starting IP address and the size of the
IP address pool.
For DHCP relay configuration, this field displays the first remote DHCP server IP address.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select the configuration entries you want to remove and click Delete to remove them.
Click Cancel to clear the check boxes.
DESCRIPTION
Enter the ID number of the VLAN you want to configure here.
Enter the number of port(s) to which you want to apply the specified DHCP option 82
profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For
example, enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
GS2210 Series User's Guide
345