Port Status - ZyXEL Communications GS2210 Series User Manual

The following table describes the fields in the above screen.
Table 9 Status > Neighbor
LABEL
Local
Port
Desc.
PoE Draw
Remote
Port
Desc.
Model
System Name
Location
Firmware
IP
MAC
PWR Cycle
Reset to Default

7.5 Port Status

This screen displays a port statistical summary with links to each port showing statistical details. To
view the port statistics, click Status in all web configurator screens and then the Port Status link
Chapter 7 Status and ZON
DESCRIPTION
This shows the port of the Switch, on which the neighboring device is discovered.
This shows the port description of the Switch.
This shows the consumption that the neighboring device connected to this port draws
from the Switch. This allows you to plan and use within the power budget of the
Switch.
This show the number of the neighbor device's port which is connected to the Switch.
This shows the description of the neighbor device's port which is connected to the
Switch.
This shows the model name of the neighbor device. This field will show "-" for non-
ZyXEL devices.
This shows the system name of the neighbor device.
This shows the geographic location of the neighbor device.
This shows the firmware version of the neighbor device. This field will show "-" for
non-ZyXEL devices.
This shows the IP address of the neighbor device. The IP address is a hyper link that
you can click to log into and manage the neighbor device through its web
configurator. This field will show "-" for non-ZyXEL devices.
This shows the MAC address of the neighbor device. This field will show "-" for non-
ZyXEL devices.
Click the Cycle button to turn OFF the power of the neighbor device and turn it back
ON again. A count down button (from 5 to 0) starts.
Note:
• The Switch must support power sourcing (PSE) or the network device is a
powered device (PD).
• If multiple neighbor devices use the same port, the Cycle button is displayed only
on the first device, others will show "-" instead.
Click the Reset button to reset the neighbor device to its factory default settings. A
warning message "Are you sure you want to load factory default?" appears
prompting you to confirm the action. After confirming the action a count down button
(from 5 to 0) starts.
Note:
• The Switch must support power sourcing (PSE) or the network device is a
powered device (PD).
• If multiple neighbor devices use the same port, the Reset button is not available
and will show "-" instead.
• You can only reset ZyXEL products.
GS2210 Series User's Guide
59