Pontiac Fiero 1988 Service Manual page 870

MUNCIE 282 (5-SPEED) MANUAL TRANSAXLE
113-9
1 - ALIGNMENT PIN
2- TRANSAXLE CONTROLS
3 - SHlFT CABLE
4 -
NUT
5 - LEVER
6 - LOCKING PIN
7 - SELECT CABLE
8 -
NUT
9 - LEVER
H20G11-7B3
Figure 4 Cable Adjustment at Transaxle
CHECKING FLUID L E V E L
Check the fluid level only when the engine is off,
the vehicle is level and the transaxle is cool enough to let
you rest your fingers on the transaxle case. To check the
fluid level, remove dipstick and read level indicated.
When the dipstick indicates H, (hot) is full when the
transaxle is warm. If the dipstick indicates ADD or be-
low, add fluid. Syncromesh Transmission Fluid
(12345349) or equivalent lubricant to fill transaxle. Be
sure the fluid level is between the H (hot) and C (cold)
marks on the dipstick.
ON-VEHICLE SERVICE
TRANSMISSION SHIFT C A B L E S
Remove or Disconnect
1. Negative battery cable.
2. Screw and shift knob.
3. Front trim plate, see Section 8C.
4. Shifter trim plate.
5. Rear console pad assembly.
6. E.C.M., see Section 6E2.
7. E.C.M. electrical connections.
8. Front carrier to I.P. reinforcement, see Section
8C.
0
1
2
3
4
5
6
17
18
2
3
4
5
6
7
8
9
10
Carpet clips and rivets at console.
Heater control.
Radio, see Section 9A.
Carrier assembly, see Section 8C.
Shift and select cable nuts from cable ball studs
and transaxle brackets.
Release rubber grommet on cable from body.
Bolt and retainer securing shift cable to
transaxle.
Retainers from select and shift cable.
Pull cables through body into passenger
compartment.
Install or Connect
Guide cable from passenger side through body
into engine compartment.
Select cable with retainer.
Shift cable to retainer with bolt 25 Nnn (18 lb.
ft.).
Rubber grommet on cable and body.
Shift and select cables with nuts 25 Nnn (18 lb.
ft.) on cable studs to transaxle brackets.
Carrier assembly, see Section 8C.
Radio, see Section 9A.
Heater control, see Section 8C.
Carpet clips and rivets at console.