A/C Outlet Tube Assembly - Pontiac Fiero 1988 Service Manual

AIR CONDITIONING 1B-33
1 - CLAMP 6 - TUBE & HOSE ASSY. - INLET
2 - NUT 7 - TUBE ASSY. - OUTLET
3 - HOSE ASSY. 8 —O-RING (COMPRESSOR)
4 - BOLT 9 - A/C COMPRESSOR
5 - CAP
5 2 0 2 3 6 - 1 B
Figure 33 A/C Coupled Hose Assembly — Typical
p « f install or Connect
1. A/C inlet tube and hose assembly.
2. Fuel tank reinforcement.
3. Heat shield.
4. Four underbody A/C tube clamps.
5. Lower vehicle.
6. Inlet tube at compressor hose assembly.
Tighten
Torque to 41 Nnn (30 ft. lbs.).
7. Front compartment panel seal.
8. Spare tire storage panel.
9. Jack assembly.
10. Spare tire assembly.
11. Inlet tube at accumulator.
\Q\ Tighten
Torque to 41 N-m (30 ft. lbs.).
12. Negative ( - ) battery cable.
13. Evacuate and charge system.
A / C O U T L E T T U B E A S S E M B L Y
Remove or Disconnect
1.
Negative ( —) battery cable.
2. Discharge system.
3.
Spare tire assembly.
4.
Jack assembly.
5. Spare tire storage panel.
6. Rear compressor outlet tube at front compressor
outlet tube.
7.
Open deck lid.
8. Compressor outlet tube at compressor hose
assembly.
9. Raise vehicle.
10.
Heat shield.
11. Four underbody A/C tube clamps.
12.
Fuel tank support.
13.
A/C outlet tube.
E3
Install or Connect
i.
A/C outlet tube.
2. Fuel tank support.
3.
Four underbody A/C tube clamps.
4.
Heat shield.
5. Lower vehicle.
6. Rear compressor outlet tube to front compressor
outlet tube.