Pontiac Fiero 1988 Service Manual page 736

ON-VEHICLE SERVICE 7A1-13
E 3
A d
«
u s t
• Make all necessary adjustments to T.V.
cable as outlined below.
T.V. C a b l e A d j u s t m e n t
1. Prior to adjustment check that cable is in full
non-adjusted position.
2. Check that the T.V. cable is connected at trans-
axle and working freely.
3. Check T.V. cable for twists or kinks.
4. Be certain accelerator cable is installed before
adjustment is made.
5. Rotate idler pulley counter clockwise to 7 Nnn
(65 lb. in.) for adjustment with.
AUTOMATIC (SHIFT CABLE)
F+| Remove or Disconnect
1. Negative ( —) battery cable.
2. Front trim plate and shift knob.
3. Shift trim plate rear console pad assembly and
front pad assembly.
4. E.C.M. electrical connection.
5. E.C.M.
6. Front carrier to I.P. reinforcement.
7. Carrier reinforcement.
8. Carpet clips and rivets at console.
9. Heater control.
10. Radio.
11. Carrier.
12. Shift cable from shifter control assembly.
13. Cable from shift lever at transaxle.
14. Yoke clip securing shift cable to transaxle
mounting bracket.
15. Pull cable through body into the passenger
compartment.
Install or Connect
1. Pilot cable from passenger side through body
into engine compartment.
2. Clip cable to transaxle mounting bracket.
3. Snap cable to shift lever.
4. Clip cable in place at fuel line.
5. Cable to shifter bracket.
6. Cable end to shift lever pin.
7. Carrier assembly, console.
8. Radio.
9. Heater control.
10. Carpet clips and rivets at console.
11. Carrier reinforcements.
12. E.C.M.
13. E.C.M. Electrical connections.
14. Front pad assembly.
15. Front pad trim plate.
16. Rear console pad assembly.
17. Shift trim plate, and shift knob.
18. Negative ( —) battery cable.
L O A N D R E V E R S E P I P E S
E
Remove or Disconnect
1. Raise vehicle and suitably support, see
Section OA.
2. Oil pan.
3. Oil strainer and "O" ring seal.
4. Reverse oil pipe, seal back-up ring and "O" ring
seal.
5. Low and reverse cup plug assembly.
E
Install or Connect
1. Low and reverse cup plug assembly.
2. Reverse oil pipe back-up ring with a new "O"
ring.
3. Oil strainer with a new "O" ring.
4. Oil pan.
5. Lower vehicle.
1 7 1 Adjust
• Fluid level. Refer to Section 7A.
P A R K I N G P A W L S H A F T
E
Remove or Disconnect
1. Raise vehicle and suitably support.
2. Oil pan.
3. Oil strainer and " 0 " ring seal.
4. Fluid level indicator stop.
5. Rod retainer and parking lock bracket.
6. Clip, pin, rod and spring.
B
Install or Connect
m Refer to exploded view in the Transaxle Unit
Repair Section.
1. Rod, spring, clip and pin.
2. Rod retainer and parking lock bracket.
3. Fluid lever indicator stop.
4. Oil strainer with a new "O" ring.
5. Oil pan. Refer to Section 7A.
6. Lower vehicle.
0 Adjust
• Fluid level. Refer to Section 7A.