Pontiac Fiero 1988 Service Manual page 119

2A-2 FRAME (CRADLE) AND MOUNTS
4. Both fixed adjusting links at knuckle.
5. Both trailing arms at knuckle.
6. Stabalizer brackets at cradle. (GT only)
7. Emergency brake cable at cradle.
8. Engine and transmission mounting bolts.
9. Cradle bolts.
10. Cradle assembly.
* Transfer parts.
E
Install or connect
1. Cradle assembly.
2. Cradle bolts.
• Front nuts and bolts finger tight at first.
3. Engine and transmission mounting bolts.
4. Emergency brake cable at cradle.
5. Stabalizer brackets at cradle. (GT only)
6. Both trailing arms at knuckle.
7. Both fixed adjustable links at knuckle.
8. Both rear lateral control arms at knuckle.
9. Exhaust pipe bolts at manifold.
10. Rear wheel and tire assemblies.
|5!J Tighten
• Torque the following as indicated.
1. Front cradle bolts 90 Nnn (67 lbs.
ft.)
2. Rear cradle nut 103 Nnn (76 lbs.
ft.)
10
11
12
13
Engine mount assembly 54 N ® m (38
lbs. ft.)
Rear Mount assembly 48 Nnn (36
lbs. ft.)
Front mount assembly 48 N*m (36
lbs. ft.)
Rear lateral control arm at knuckle
50 Nnn (37 lbs. ft.) + 90°
Rear lateral control arm at cradle 55
Nnn (41 lbs. ft.) + 105°
Fixed adjusting link at knuckle 50
Nnn (37 lbs. ft.) + 90°
Fixed adjusting link at cradle 55
Nnn (41 lbs. ft.) + 105°
Trailing arm to cradle 51 Nnn (37
lbs. ft.) + 80°
Trailing arm to knuckle 60 Nnn (44
lbs. ft.) + 90°
Stabalizer bar bracket mounting
bolts 25 N-m (18 lbs. ft.)
Exhaust pipe bolts at manifold 25
Nnn (18 lbs. ft.)
| * * | Remove or Disconnect
1. Lower vehicle
2. Support Fixture
Adjust
Toe-in, and parking brake assembly.
• (See Section 3A, Front and Rear
Alignment and Section 5, Brakes)