Pontiac Fiero 1988 Service Manual page 918

HYDRAULIC CLUTCH
7C-H
Procedure
NOTICE:
Always remove the floor mat or any
other object which may obstruct the full stroke of
the pedal.
1. Unscrew bleedscrew at slave cylinder enough to
allow fluid to be pumped out (half a turn is
normally sufficient).
2. Push pedal down through full stroke.
3. Allow pedal to return quickly to its stop by
removing foot from the clutch pedal.
4. Close bleedscrew immediately after last down-
ward stroke of pedal when air bubbles no longer
appear.
5. Repeat procedure until air is dispelled at
bleedscrew.
CLUTCH SHAFT AND/OR BUSHINGS
F + l Remove or Disconnect
Tools Required:
J36037 Bushing Remover/Installer
J36032 Bushing Remover
J23907 Slide Hammer
J36190 Driver
1. Transaxle assembly, see Section 7B2 or 7B3.
2. Clutch release lever.
3. Clutch dust seal.
4. Drive upper bushing with J36037 into housing.
5. Clutch shaft and upper bushing. Slide shaft out
of case at a slight angle.
6. Lower bushing using J36032 with J23907.
— Engage second step on J36032 below
bushing and tighten screw to expand legs.
F*l Install or Connect
1. Lower bushing using J36033 with J36190.
2. Clutch shaft.
3. Upper bushing.
— Drive bushing into housing until line on
J36037 is flush with housing surface.
4. Dust seal.
5. Clutch release lever.
— 50 Nnn (37 lb. ft.).
6. Transaxle assembly, see Sections 7B2 or 7B3.
0 Adjust
e Fluid Level.
— Manual transaxle oil 5W-30, #1052931
or equivalent.
— Lube capacity 1.9 liters (2 quarts).
m J36037
IT1 UPPER BUSHING
H2CMJ02-7C
Figure 15 Upper Bushing
Removal
K2G0G3-7C
|
i
Figure 16 Lower Bushing
Removal
[Tl
L O W E R
BUSHING \
fTI
J36033 \
fTI
J36190
1
H 2 C 0 0 4 - 7 O i
Figure 17 Lower Bushing Installation