Pontiac Fiero 1988 Service Manual page 902

UNIT REPAIR MUNCIE 282
(5-SPEED)
TRANSAXLE 7B3A-23
NOTICE: POSITION SHIFT RAILS SO THE STH GEAR
SHIFT RAIL 197 IS 1/4" BELOW THE OTHER
THREE SHIFT R A I L S - A L L THREE MUST BE
AT THE SAME HEIGHT
A. ASSEMBLED DETENT HOLDER AND SPRING ASSEMBLY
169 (VIEW A) WITH SPRINGS 170, PINS 168 AND
THE DETENT BALL 171 FOR THE REVERSE SHIFT
RAIL 183.
INSTALL DETENT BALLS WITH SCREWDRIVER (VIEW B):
B. 1-2 SHIFT RAIL 190
C. 3-4 SHIFT RAIL 184
D. 5TH GEAR SHIFT RAIL 197
169. HOLDER, DETENT
183. SHAFT, REVERSE SHIFT
184. RAIL, 3RD/4TH SHIFT ASSEMBLY
190. RAIL, 1ST/2ND SHIFT ASSEMBLY
197. RAIL, STH SHIFT ASSEMBLY
139. SNAP RING
140. C O V E R
141. S C R E W , 9.0 N-m (84 lb
142. S P R I N G S E A T , OUTER
143. S P R I N G
144. S P R I N G S E A T , INNER
GX1255-MN5TX
n.)
Figure 32 Detent Holder Installation
use small amount of threat sealant GM
P/N—1052624 or equivalent, 9.0 N-m (84
lb in).
5. Protective cover (140).
position to below snap ring groove.
6. Snap ring (139).
Figure 33 Shift Shaft Detent Components/Transmission
Housing
EXTERNAL TRANSAXLE MOUNTED LINKAGE
INSTALLATION
|-»4-J Install or Connect (Figure 34)
1. Bracket (121).
2. Bolts (123).
- 23 N-m (17 lb ft).
3. Collar (125) and pin (126).
4. Pivot (124) and pin (122).
5. Retainer (120).
6. Lever (127).
7. Washer (128) and nut (129).
- 83 N-m (61 lb ft).
- DO NOT ALLOW lever (127) to move
during installation of nut (129).
8. Fluid level indicator assembly (110).
9. Electronic speedo sensor assembly (172), retainer
(212) and bolt (213).
- 9 N-m (84 lb. in.)