Pontiac Fiero 1988 Service Manual page 741

7A1-18 ON-VEHICLE SERVICE
13. Enging mounts to cradle nuts. (2)
14. Exhaust to manifold.
15. Brake control cable at frame.
16. Brake cables to calipers.
E 3
A d J u s t
1. Brake cable. (See Section 5)
17. Splash shields.
18. Disconect rear axle shaft from support.
19. Rear axle shaft to transmission. (See Section
4D)
20. Trailing arms to knuckles.
HI
Tighten
1. Torque trailing arm at knuckle to 60 N®m
(44 lbs. ft.) +90°.
21. Fixed adjusting link/lateral control arm through
bolts.
II
Tighten
1. Torque fixed adjusting link/lateral control
arm through bolt to 50 N*m (37 lbs. ft.)
+ 90°.
22. Remove rear axle boot protector.
23. Rear wheels.
24. Remove jack stands and lower vehicle.
25. Remove engine fixture tool J 28467-A.
26. Neutral start switch harness and shift cable
bracket.
27. Transmission to engine retaining bolts.
28. Transmission cooler line support bracket.
29. Wire harness at transmission to engine retaining
bolts.
30. Speedometer pick-up electrical connection.
31. Transmission converter clutch electrical
connection.
32. Neutral start switch electrical connection.
33. Shift cable to transmission bracket.
34. Throttle valve cable to transmission and
carburetor.
35. Left engine vent cover.
36. Right engine vent cover.
37. Air cleaner.
38. Battery negative ( - ) cable.