Pontiac Fiero 1988 Service Manual page 195

3C-10 FRONT SUSPENSION
SPECIFICATIONS
T O R Q U E SPECIFICATIONS
Bolt:
U.C.A. Shaft To Crossmember 70 N-m (52 lb. ft.) + 1/4 turn (90°)
Nut:
L.C.A. To Crossmember 50 N«m (37 lb. ft.) + 3/4 turn (270°)
Nut:
U.C.A. Ball Joint To Knuckle 40-55 N«m (30-40 lb. ft.)
Note: (1/6 turn to align cotter pin) not to exceed 75 N»m (55 lb. ft.)
Nut:
L.C.A. Ball Joint To Knuckle 35 N-m (26 lb. ft.) + 1/2 turn (180°)
Note: Maximum 1/6 turn to align cotter pin
Bolt:
Steering Gear To Crossmember 27 Nnn (20 lb. ft.)
Nut:
Tie Rod At Knuckle 20 Nnn (15 lb. ft.) + 1/2 turn (180°)
Note: Maximum 1/6 turn to align cotter pin
Bolt:
Hub and Bearing To Knuckle 260 Nnn (220 lb. ft.)
Nut:
Upper Shock 11 Nnn (8 lb. ft.)
Bolt:
Shock to L.C.A 27 N«m (20 lb. ft.)
Bolt:
Stabilizer Bar Bushing Clamp 27 Nnn (20 lb. ft.)
Nut:
Stabilizer Bar Link 17 Nnn (12 lb. ft.)
SPECIAL TOOLS
J-6627-A
J-26407
J-21474-5
J-21474-18
J-21474-191
J-21474-23|
J-37162-1
J-37162-2
J-9519-10
J-9519-18
J-37161-1
J-37161-2
J-37161-3
J-37161-4
Wheel Stud and Tie Rod End Remover
Ball Joint Remover
- Control Arm Bushing Remove/Install Assembly
- Lower Ball Joint Remove/Install Assembly