BRAKES 5-15
Install or Connect (Figures 13 and 14)
NOTICE: See "Notice" on page 5 - 1 .
1. Combination valve.
2. Bolt attaching valve to bracket.
Tighten
• Bolt to 6 N-m (54 lbs. in.).
3. Wiring harness to valve switch terminal.
4. Hydraulic pipes at combination valve.
• Bleed brakes. See "Bleeding Brake Hydraulic Sys-
tem" in this section.
CAUTION: Do not move the car until a firm brake
pedal is obtained. Air in the brake system can
cause loss of brakes.
1 - BOOSTER
2 - PIPE
3 - VALVE
4 - BOLT
5 - BRAKE PIPE - RR
6 - PIPE - R H
7 - PIPE - L H
8 - BRACKET
J 1 0 0 1 4 - 5 - P
Figure 14 Combination Valve to Master Cylinder
Mounting