Pontiac Fiero 1988 Service Manual page 443

6 E - 1 6 D R I V E A B I L I T Y A N D E M I S S I O N S - FUEL I N J E C T I O N
FEMALE
C O N N E C T O R
BODY
M A L E
C O N N E C T O R
B O D Y
©PEW SECONDARY LOCK H I N G E OW C O N N E C T O R
REMOVE
T E R M I N A L USING TOOL
PUSH TO
RELEASE
TERMINAL R E M O V A L
T O O L J-28742
3. C U T W I R E IMMEDIATELY B E H I N D C A B L E
SEAL
REPLACE T E R M I N A L
A . S L I P NEW S E A L ONTO W I R E .
8. STRIP 5 m m (.2") OF I N S U L A T I O N F R O M W I R E .
C. CRIMP T E R M I N A L O V E R W I R E A N D S E A L .
E A L
5.
PUSH T E R M I N A L A N D C O N N E C T O R A N D
E N G A G E L O C K I N G TANGS.
6.
CLOSE SECONDARY LOCK HINGE
04 mm
6S I S S S - S i
Figure 6 - Weather-Pack Terminal Repair
C o m p a c t Three
The compact three connector, which looks similar
to a Weather-pack connector, is not sealed and is used
where resistance to the environment is not required.
This type of connector most likely is used at the air
control solenoid. Use the standard method when
repairing a terminal. Do not use the Weather-pack
terminal tool J-28742.
Metri-Pack Series 150 Terminal Removal
Some connectors used to connect various sensors
to the ECM harness use terminals called "Metri-Pack"
(Figure 7). These may be used at the Coolant Sensors
as well as at ignition modules.
They are also called "Pull-To-Seat" terminals
because, to install a terminal on a wire the wire is first
inserted through the seal (5) and connector (4). The
terminal is then crimped on the wire, and the terminal
pulled back into the connector to seat it in place.
To remove a terminal:
1. Slide the seal back on the wire,
2. Insert tool (3) BT-8518 or J 35689, or
equivalent, as shown in insert "A" and "B"
to release the terminal locking tang (2).
3. Push the wire and terminal out through
the connector.
If you are reusing the terminal, reshape the
locking tang (2).
Micro-Pack
Some connectors used on harness to connect to the
ECM are called Micro-Pack (Figure 8). Terminal
replacement requires the use of special tool J-33095,
BT-8234-A or equivalent.
Figure 7 - Metri-Pack Series 150 Terminal Removal