Pontiac Fiero 1988 Service Manual page 444

DRIVEABILITY AND EMISSIONS - FUEL INJECTION 6E-17
m
CABLE
| T 1 LOCKING TANG
3.
PR
TERMINAL
f T l TOOL J33095
4.
1. GRASP CABLE AND PUSH TERMINAL
TO THE MOST FORWARD POSITION.
2. INSERT TOOL J33095 STRAIGHT INTO
THE FRONT OF THE CONNECTOR CAVITY.
DO NOT USE CONVENTIONAL PICK TO REMOVE
TERMINAL.
03 21 84 •
5.
WITH TOOL IN PLACE. GENTLY PULL
ON THE CABLE TO REMOVE TERMINAL.
VISUALLY CHECK TERMINAL AND
REPLACE IF TERMINAL CAVITY OR TANG
IS DAMAGED.
INSTALL TERMINAL INTO CONNECTOR
CAVITY UNTIL LOCKING TANG HAS
SNAPPED INTO POSITION.
SS 1418-6E
Figure 8 - Micro-Pack Terminal Replacement
TOOLS NEEDED TO SERVICE THE SYSTEM
The system requires an ALDL read-out ("Scan")
tool, tachometer, test light, ohmmeter, digital
voltmeter with 10 megohms impedance (J-29125A,
J-34029A or equivalent), vacuum gage and jumper
wires for diagnosis. A test light or voltmeter must be
used when specified in the procedures. They must
NOT be interchanged. See Figures 9 through 13 for
Special Tools needed to diagnosis or repair a system.
For more complete information on the operation of
these tools, see the manufacturer's instructions.