Pontiac Fiero 1988 Service Manual page 148

STEERING, SUSPENSION, TIRES AND WHEELS DIAGNOSIS 3 7
G33914-3-AN
Fig. 3 Checking Keminder Switch Fads
G339153-AN
Fig. 4 Checking Reminder Switch
G33916-3-AN
Fig. 5 Lock Cylinder Actuator - Key Removed
pad until the switch points contact. If contact is
not made, replace reminder switch.
8. Check the switch contact gap by pressing a 0.8
mm (.030") wire-type plug gage with a flat piece
of stock onto the actuator pad. If contact is not
made, decrease the switch contact gap until
positive contact is made. Use a continuity meter
(light).
G33917-3-AN
Fig. 6 Lock Cylinder Actuator - Key in Place
A C T U A T O R
PAD
G33918-3-AN
Fig. 7 Checking Key Reminder Switch Continuity
G33920-3-AN
Fig. 8 Checking Contact Gap
9. With positive contact at 0.8 mm (.030"), use a 0.6
mm (.025") plug gap wire beneath the flat stock.
No contact should occur. If contact is made,
increase the switch contact gap. When the switch
will make contact with the 0.8 mm (.030") wire
but not with the 0.6 mm (.025") wire, the switch
is set properly.