Axle Shaft Seals - Pontiac Fiero 1988 Service Manual

7B3-14
MUNCIE
282
(5-SPEED)
MANUAL
TRANSAXLE
4. Install J 28467-A, and J 35563 engine support
fixtures. Attach fixture hook to engine lift ring
and raise enough to take the pressure off the
mounts.
5. Two nuts from studs attaching lower half of
mount to frame and remove mount.
6. Nut from stud attaching rear transaxle upper and
lower halfs.
F + l Install or Connect
1. Nut on stud 48 Nnn (35 lb. ft.) attaching upper
and lower halfs of transaxle mount.
2. Upper half of transaxle mount with stud 54 Nnn
(40 lb. ft.) and coolant pipe over stud.
3. Two bolts and one nut on stud 54 Nnn (40 lb.
ft.) attaching upper half of transaxle mount to
transaxle.
4. Lower engine and remove tools J 28467-A and J
35563.
5. Two nuts on studs 48 Nnn (35 lb. ft.) attaching
lower half of transaxle mount to frame.
6. Negative battery cable.
AXLE SHAFT S E A L S
Remove or Disconnect
1. Axle shaft and inner joint from transaxle, see
Section 4D.
2. Pry out and discard axle shaft seal from
transaxle.
B Install or Connect
1. New axle shaft seal with tool J 26938 and J
8092.
2. Axle shaft and inner joint in transaxle, see Sec-
tion 4D.
Figure 10 Special Tool Engine Support