Pontiac Fiero 1988 Service Manual page 840

5 - S P E E D mrm imm M A N U A L T R A N S A X L E 7B
5200ei»7B
Figure
3
Shift Cable & Select Cable Routing and Cable
Attachment at
Shifter
11. Carrier reinforcements.
12. E.C.M. electrical connection, see Section 6E2.
13. E.C.M.
14. Front pad assembly, see Section 8C.
15. Front pad trim plate.
16. Rear console pad assembly.
17. Shift trim plate.
18. Shift knob.
19. Negative ( - ) battery cable.
SHIFTER A S S E M B L Y
|**| Remove or Disconnect
Figure 3
1. Steps 1 thru 14 as outlined in shift cable and
select cable removal procedure.
2. Mark location of shifter assembly for
reinstallation purposes.
3. Shifter assembly nuts.
Install or Connect
1. Shifter to body at location marked.
H O
Tighten
• to 24 N-m (18 lb. ft.)
Install or Connect
1. Cables to shifter assembly.
2. Carrier and console components as outlined in
shift cable and select cable installation
procedure.
SHIFT CABLE AND SELECT C A B L E LEVER
ASSEMBLY
Remote m Disconnect
1. Cables from shift lever at transaxle.
2. Bolt from mount at transaxle.
3. Cotter pin from crosshaft through rod at shift
shaft.
4. Transaxle shift lever assembly.
Install or Connect
1. Shift lever assembly to shifter shaft.
2. Crosshaft through rod into shift lever assembly.
3. Cotter pin into through rod.
4. Bolt through mount at transaxle.
5. Shift cables to shift levers at transaxle.
SHIFT CABLE BRACKET
Remove or Disconnect
1. Shift and select cables from transaxle shift
levers.
2. Bolt through transaxle cable bracket top half and
separate cable bracket halfs.
3. Shift and select cables.
4. Bracket from transaxle.
F < 1 Install or Connect
1. Bracket to transaxle.
2. Shift and select cable to bracket.
3. Bolt through transaxle cable bracket top half and
join cable bracket halfs.
4. Shift and select cables to transaxle shift levers.