Pontiac Fiero 1988 Service Manual page 911

7C-4
HYDRAULIC CLUTCH
C L U T C H S L A V E C Y L I N D E R
1 * H
Remove or Disconnect
(Figure 6)
Hydraulic line at slave cylinder.
1.
2.
Slave cylinder to bracket bolts, remove slave
cylinder.
Install or Connect
Position slave cylinder at mounting bracket and
pilot cylinder push rod into clutch release lever.
Slave cylinder to bracket nuts.
1.
2.
E D
Tighten
Torque nut to 22 N-m (16 lb. ft.)
B Inst,!! or Connect
1 Hydraulic line to slave cylinder.
H O
Tighten
Torque line nut to 17 Nnn (13 lb. ft.).
hHI Install or Connect
1. Fill clutch master cylinder with recommended
fluid and bleed system.
C L U T C H S L A V E C Y L I N D E R B R A C K E T
Remove or Disconnect
(Figure 6)
1. Engine wire harness clamp at slave cylinder
bracket and move wires for access.
2. Slave cylinder to bracket bolts, do not discon-
nect hydraulic pipe from slave cylinder.
3. Slave cylinder bracket to transaxle attaching
bolt.
4. Slave cylinder bracket to shift cable bracket
bolt, remove bracket.
F+] Install or Connect
1. Slave cylinder bracket to transaxle.
Illl
Tighten
Torque bolt to 50 Nnn (32 lb. ft.)
L Slave cylinder bracket to shift cable bracket.
Tighten
Torque bolt to 50 Nnn (32 lb. ft.)
Install or Connect
1. Position slave cylinder to mounting bracket and
pilot slave cylinder push rod into clutch lever.
2. Slave cylinder to bracket nuts.
13
Tighten
Torque nuts to 22 Nnn (16 lb. ft.).
C L U T C H R E L E A S E L E V E R
[^j Remove or Disconnect
(Figure 61
1. Slave cylinder to bracket bolts, do not discon-
nect hydraulic pipe from slave cylinder.
2. Clutch release lever attaching bolt and remove
lever from transaxle clutch fork shaft.
Install or Connect
1. Clutch release lever on clutch fork shaft. Install
attaching bolt.
[§y Tighten
Torque to 27 Nnn (20 lb. ft.).
Install or Connect
1. Position slave cylinder to mounting bracket and
pilot slave cylinder push rod into clutch lever.
2. Install slave cylinder to slave cylinder bracket.
Tighten
Torque bolts to 22 Nnn (16 lb. ft.).
1. 38 N-m (28 L B S . FT.)
2. C L U T C H L E V E R
3. B R A C K E T
4. H E A T S H I E L D
5. 25 N-m (18 L B S . FT.)
6. S L A V E C Y L I N D E R
7. 16 N-m (12 L B S . FT.)
8. PIPE
J 1 0 2 5 1 - 7 C - P
Figure 6 Clutch Slave Cylinder & Clutch Lever Mounting